Hersey – Page 13 – Sportster Project

Foot controls…

July 11, 2019 by Hersey

The foot controls I ordered from American Classic Motors showed up yesterday. The rear brake lines and rear brake light switch I ordered from J&P Cycles had showed up on Tuesday. I had plan to wait till the weekend to get them…

No comment

Cleaning up the garage a bit…

July 8, 2019 by Hersey

Hope everyone I had a great 4th of July weekend! Took the down time to clean up the garage a little. Just getting rid of all the parts boxes, sweeping the floor, wiping down the lift, putting tools away, organizing, and such….

No comment

Handlebars and controls…

July 4, 2019 by Hersey

Happy 4th!!! Man was it hot out in the garage yesterday afternoon. UPS showed up with the new, correct length, idle and throttle cables I ordered so after work I did a bit of tinkering on the project. The handlebars and controls…

No comment

Iron Butt SaddleSore Challenge… The Plan…

July 2, 2019 by Hersey

I have been doing a lot of working on motorcycles lately and not nearly enough riding. I wanted to put a plan together for me and Sandy to do something cool over the summer. I did an Iron Butt SaddleSore 1000, 1000…

No comment

Just some tinkering…

July 1, 2019 by Hersey

Had a busy weekend so only did a little tinkering on the 1992 project. The throttle cables and grips were delivered early last week and the hand controls were delivered on Friday. My granddaughter was with us over the weekend so she…

No comment

She RUNS!!!

June 23, 2019 by Hersey

Had some time Friday after work to get things buttoned up and give starting her up a try. Wasn’t much left to do: connect the coil, add some oil, put some fuel in the tank, cross our fingers, and hope for the…

No comment

Hot pipes and a few other odds and ends…

June 13, 2019 by Hersey

Had a couple of hours last night after work so I tinkered a bit and made some more progress towards making her run. Belt drive primary is on, exhaust is on, carburetor is on, transmission is buttoned up, most of the wiring…

No comment

Harley Davidson Vehicle Operations Tour…

June 11, 2019 by Hersey

This past weekend Sandy and I traveled up to New Hampshire to celebrate the wedding of some good friends of ours. It was a beautiful ceremony and a great time. On the way home we had time to take a slight detour…

No comment

Interesting… Peanut City Chop and Swap

June 6, 2019 by Hersey

Updated 06/19/2019 – Don’t know much about this, but putting it here so I can check into it later. The only info I have seen so far is on the Instagram page @peanut_city_chop_and_swap. The page says it’s going to be a Vintage…

No comment

Compu-Fire HDE-1 Ignition Static Timing…

June 2, 2019 by Hersey

For the EVO project I am using the Compu-Fire HDE-1 Digital Electronic Ignition. I used this same set up on the 1990 Sportster Project, it was easy to set up and so far it works well. I decided to do something a…

6 Comments

Sportster Project

Sportster Hardtail Rear Brake Bracket…

Sportster Hardtail Progress…

Cutting the Sportster in Half…

Measure 3157 times…

Hardtailing the 90 Sportster…

Registering an Antique Motorcycle

90 Sportster Leaky Fork Seal…

Rebuilding the carb for the 90 Sportster…

Cleaning the carb for the 90 Sportster…

Sportster Project YouTube Channel…

Author: Hersey

Foot controls…

Cleaning up the garage a bit…

Handlebars and controls…

Iron Butt SaddleSore Challenge… The Plan…

Just some tinkering…

She RUNS!!!

Hot pipes and a few other odds and ends…

Harley Davidson Vehicle Operations Tour…

Interesting… Peanut City Chop and Swap

Compu-Fire HDE-1 Ignition Static Timing…