Little something for the tank. Nothing fancy. Just some SportsterProject.com goodness for the ’88. Picked these up from StickerYou.com.
Build. Tinker. Ride. Trials and Tribulations (and good times) of my motorcycle projects and other garage tinkering. Learning and building things. Building, wrenching on, and riding Harley Davidson Evolution Sportsters, Big Twins, and anything else with two wheels. Currently working on restoring and preserving a 1988 Harley Davidson Sportster chopper. I also post information on other DIY projects I tinker on.
Little something for the tank. Nothing fancy. Just some SportsterProject.com goodness for the ’88. Picked these up from StickerYou.com.
Did a little work on the 1988 Sportster project last night and she is almost ready to take for a ride. Nowhere near finished, but almost to the point I should be able to hop on and take her for a spin.
Hope everyone is staying safe and well. Got the front fender and tank painted over past week and weekend. Nothing fancy just rattle can satin black. Prepared the tank and fender, hit them with some self-etching primer, then a few coats of…
Hope everyone is staying safe and well. Been doing a little work on the bike as well as some other small projects around the house and garage. I picked up a cheap forward control kit on eBay. The kit is for a…
I have been trying to figure out what I was going to do for the air cleaner on the 1988 Sportster Project. There are a lot of options out there, and I am trying to keep the cost down. The intake manifold…
On the 1988 Sportster project I am using a front brake caliper from a sportbike… I have the single piston Harley Davidson stock front brake caliper and was planning to just rebuild it and run it but I was watching some YouTube…
I am building a sissy bar for the 1988 Sportster from some 1/2″ steel round stock I picked up from JR Enterprises in Chesapeake. A little bit of bending, a little bit of welding, and a lot of grinding. Worked on this…
The 1988 Sportster Project got some tires this past weekend. I had ordered a set of Shinko 777s from Tidewater Motorcycles and picked them up earlier in the week. Front tire is a 100/90-19 and the rear tire is a 130/90-19.
Back in August 2019 Sandy and I rode just over 1000 miles in about 17 hours for the Iron Butt Saddle Sore 1000 Challenge. I submitted the documentation of the ride and the necessary paper work to the Iron Butt Association to…
Friday night I finally had everything together to give starting the 1988 Sportster a go. Ignition in and static timing set, oil in the tank, primary oil in and primary chain adjusted, and the exhaust mounted. I wired up a temporary oil…